User's Manual

28 Using Dell PRO Pack
Recovery Action Overrides
PRO Pack 2.0 supports two recovery actions. The following flag values trigger
the respective recovery action:
• 1: For migration recovery action
• 2: For placing the server in restricted mode
You can override the default recovey actions by changing the default recovery
action flag value. For example, change the recovery flag value from '2' to '1'
with the overrides option provided in SCOM
After overriding the default value to '1', and on implementation of PRO Tip,
recovery action will trigger migration of virtual machines from the host.
PRO Pack 2.0 supports only two override values, '1' and '2'. If you enter any
other value, PRO Tip implementation fails and an error message is displayed.
To override the recovery action,
1
Click the Authoring tab in SCOM.
2 Search for the Dell PRO Pack monitors.
3 Select the monitor which you intended to override.
4 Right click and select Override Recovery.
5 Select the Override check box.
6 Change the value of RecoveryOverrideFlag.
NOTE: When you select Enable, SCOM performs an auto-implementation for
the unit monitor. Since, this involves VMM migration, review and set the
values accordingly.
7 Select Enforce check box.
8 Click Apply
CAUTION: Saving the settings in the default management pack, creates a
dependency between PRO Pack and the management pack. When you remove or
delete PRO Pack, you must delete the default management pack as well, as it
contains default settings for SCOM. Hence, it is recommended that you save
settings using a new MP.
9 Click Save overrides.
10 Generate an alert and PRO Tip.
11 Select Implement PRO Tip .
book.book Page 28 Thursday, December 10, 2009 12:36 PM