Owner's Manual

file:///T|/htdocs/SOFTWARE/smconect/msscom/41/en/Readme/DellMPv41_CMC_Readme.txt[10/23/2012 10:16:15 AM]
* The Discovery Rule "Dell DRAC/MC Slot Discovery" is disabled for all Dell
Modular Chassis Remote Access Controllers in the Dell Chassis Management
Controller Management Pack. Enable this rule to discover server modules
and free slots for Dell Modular Chassis Remote Access Controllers after
you have created Run As Accounts for the DRAC/MC devices in your network
and associated them with the "Dell DRAC/MC Login Account". For more
information on configuring Run As Accounts refer to "Dell Server
Management Pack Suite Version 4.1 For Microsoft System Center
Operations Manager 2007 SP1/R2 and System Center Essentials 2007
SP1/2010 User’s Guide"
Note:- A user can enable the "Dell DRAC/MC Slot Discovery" Discovery if
required by using overrides in a custom Management Pack.
* The Unit Monitor "Device Status Check" is disabled for all Dell
Chassis Management Controllers and Dell Modular Chassis Remote Access
Controllers in the Dell Chassis Management Controller Management
Pack.
Note:- A user can enable the "Device Status Check" Unit Monitor if
required by using overrides in a custom Management Pack.
* "Dell CMC Slot Discovery" and "Dell DRAC/MC Slot Discovery" uses
racadm to connect to CMC and DRAC/MC devices. The racadm uses
Internet Explorer Proxy Settings of SCOM Health Service user account
to connect to the CMC and DRAC/MC Devices. Ensure that Internet
Explorer Proxy Settings of the SCOM Health Service user account is
configured such that CMC and DRAC/MC devices are reachable.
For instructions on modifying the Internet Explorer settings,
see Microsoft KB article 135982.
#####################################################################
KNOWN ISSUES
#####################################################################
* After you remove the management pack, you will need to close and
re-open the Operations Console for complete cleanup (DF310069)
* For slots corresponding to CMCs with firmware version 2.x, only the
default names are displayed. (DF424948)
* For CMC devices, "Service Tag" attribute value is same as the Chassis
Service Tag. (CR414439)
* After upgrading the management packs to 4.1, you may see the Diagram
view still displaying default icons. You need to restart Operations
Console with /clearcache option to see the new icons. (DF425901)
* You cannot discover slots for DRAC/MC devices with firmware
version 1.6 with an Active Directory (AD) account. Alternatively,
you can discover the slots with Local User Accounts. (DF431523)