Users Guide

The Launch Dell OpenManage Power Center task allows you to launch the OpenManage Power Center
console.
To launch Dell OpenManage Power Center:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views
.
3. In the Tasks pane, select Dell Server Tasks → Launch Dell OpenManage Power Center.
Launch Dell Remote Access Console
To launch Dell Remote Access console:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
3. In the Tasks pane, select Dell Windows Server Tasks → Launch Dell Remote Access Console.
Launch Dell OpenManage Server Administrator
To launch Server Administrator:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views
.
3. In the Tasks pane, select Dell Windows Server Tasks → Launch Server Administrator.
NOTE: The Dell Server Management Pack Suite tasks launch the remote console in the Internet
Explorer.
Launch Remote Desktop
To launch remote desktop:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
3. In the Tasks pane, select Dell Windows Server Tasks → Launch Remote Desktop.
NOTE: Launching remote desktop is possible only if the remote desktop is enabled manually in
the managed node.
Power Cycle
The Power Cycle task allows you to turn off the Dell server and turn it on again after a delay.
NOTE: To enable Advanced Power Control, install BMU in the default path. If BMU is not installed in
the default path, create a new console task. For more information on creating a new console task,
see Creating Advanced Power Control And LED Identification Tasks.
To run the power cycle:
1. In the OpsMgr console, navigate to a Diagram Views, State Views, or Alert Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
30