Users Guide

To get warranty information:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views
.
3. In the Tasks pane, select Dell Server Tasks → Get Warranty Information.
Launch Dell OpenManage Server Administrator (Monolithic Server)
NOTE: Launching OpenManage Server Administrator is possible only if Windows or Linux operating
system and OpenManage Server Administrator is installed on the managed node.
To launch Server Administrator from the OpsMgr console on Monolithic Servers:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
3. In the Tasks pane, select Dell Server Tasks → Launch Dell OpenManage Server Administrator
(Monolithic Server).
NOTE: The Dell Server Management Pack Suite tasks launch the remote console in the Internet
Explorer.
Launch Remote Desktop (Monolithic Server)
NOTE: Launching remote desktop is possible only if the Windows operating system is installed and
remote desktop is manually enabled on the managed system.
NOTE: Remote Desktop task uses hostname to connect to the management server of a system. If
the management server cannot resolve the hostname then, add the hostname and the IP address to
a route to the server using its hostname that is configured on the management server.
To launch Remote Desktop from the OpsMgr console:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
3. In the Tasks pane, select Dell Server Tasks → Launch Remote Desktop (Monolithic Server).
Launch Dell OpenManage Power Center
You can use this task to launch the OpenManage Power Center console.
To launch Dell OpenManage Power Center:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
3.
In the Tasks pane, select Dell Windows Server Tasks → Launch Dell OpenManage Power Center.
Launch Dell Remote Access Console
To launch Dell Remote Access Console:
1. In the OpsMgr console, navigate to a Dell Diagram Views, State Views, or Alerts Views.
2. Select the desired Dell server in any of the Diagram Views or State Views or an alert in the Alerts
Views.
47