User's Manual

5
Tasks
Tasks are available in the Tasks pane of the OpsMgr console. When you select a device or a component, the relevant
tasks appear in the Tasks pane.
NOTE: In System Center Operations Manager 2007 R2 or System Center Essentials 2010, the Tasks pane is referred
to as Actions pane.
You can run all the tasks from the Diagram Views, State Views, or Alert Views.
Task Summary
Performing Dell Tasks Using Dell Server (In-band)
Following table provides a summary of the Dell tasks that you can perform using Dell Server (In-band):
Table 17. Dell Tasks Using Dell Server (In-band)
Task Description
Launch Dell OpenManage Server Administrator Launches the Dell OpenManage Server Administrator.
NOTE: Launching OpenManage Server Administrator
is possible, only if Dell OpenManage Server
Administrator is installed on the managed node.
Launch Dell OpenManage Power Center Launches the Dell OpenManage Power Center console on
the Management Server.
Launch InBand Dell Remote Access Console Launches the DRAC console for the in-band
discovered DRAC.
Launch Dell License Manager On 32 bit Management
Server
Launches the Dell license manager on management
systems running 32-bit operating system.
Launch Dell License Manager On 64 bit Management
Server
Launches the Dell license manager on management
systems running 64-bit operating system.
Clear ESM Logs Backs up the content of the Embedded System
Management (ESM) log and clears the ESM log file for
a selected system.
Launch Remote Desktop Launches the remote desktop for the selected system.
Check Power Status Checks the overall power status of the system.
Force Power Off Turns off the system power without shutting down the
operating system.
Power Cycle Turns off the power, and after a delay, turns it on again.
Power Off Gracefully Shuts down the operating system first, then turns off the
system power.
41