Users Guide

ManualsBrandsDell ManualsActive System ManagerServer Deployment Pack Version 3.1 for Microsoft System Center Configuration Manager

Command line options

DSDP supports the command line options supported in Dell Deployment Toolkit.

For more information about the command line options, usage guidelines, and syntax, see Dell OpenManage Deployment Toolkit

Version 4.4 Command Line Interface Reference Guide

The SYSCFG and RAIDCFG commands are supported in DSDP

• SYSCFG — The Deployment Toolkit (DTK) system configuration utility SYSCFG commands enable you to run commands to get

information about configuration file format, and individual executables used to configure server BIOS, DTK state settings, and

system information including PCI device detection.

• RAIDCFG — The Deployment Toolkit (DTK) RAID configuration utility RAIDCFG provides commands to configure all supported

RAID controllers.

NOTE: To get correct results, it is recommended that you type command line options in the Task Sequence wizard.

—acpower

Table 3. SYSCFG Command

Option

--acpower

Valid Arguments on, off, last

Description Sets the behavior for the system after AC power is lost. This option specifies how the

system responds to the restoration of AC power and is particularly useful in systems

that are turned off using a power strip. When set to on, the system turns on after AC

is restored. When set to off, the system does not turn on after AC is restored. When

set to

last, the system turns on if the system was on when AC power was lost. If the

system was off when AC power was lost, the system remains off when power is

restored. This option can be replicated.

Example:

A:>syscfg --acpower=on acpower=on

Applicable Systems All Dell PowerEdge systems prior to PowerEdge 12G systems.

When using this command in DSDP, remove syscfg and run the command

--acpower=on acpower=on

Table 4. RAIDCFG Command

Mandatory Options

and Arguments

Optional Parameters Valid Parameters

Arguments

Description

-vd -vd=id -

ac=svdn - vdn=

<string> - c=id or

vdisk vdisk= id

action= setvdname

vdname=<string>

controllerid= id

NA NA

Sets the name of the specified virtual disk on the

specified controller.

Example:

A:>raidcfg -vd -vd=2 -ac=svdn -

vdn=xxx -c=2

RAIDCFG Command successful!