Owner's Manual

Troubleshooting 48
5
Troubleshooting
Task sequences fail or act incorrectly after an upgrade
In order for the task sequences to function correctly on systems running
Configuration Manager 2007 SP1:
1
Launch the task sequence editor. For more information see, Editing a Task
Sequence.
2 Edit each task sequence action. For example, for each Dell custom action
sequence present add a “
. ” to the Description and then remove it. This
enables the
Apply button.
3 While upgrade if you selected Remove WinPE DTK option, then for the
Diskpart clean step to correct the error click Browse under Package and
select
Dell PowerEdge Custom Reboot Script 2.0 .
4 Press Apply , which will refresh the properties of the custom action
sequence and save any new data or formatting required to function with
the new version.
In order for the task sequences to function correctly
on systems running
Configuration Manager 2007 SP2:
1
Launch the task sequence editor. For more information see, Editing a Task
Sequence.
2 Remove the Set RebootStep Va r ia b l e step in the task sequence.
3 Remove all the Reboot to PXE/USB steps in the task sequence.
4 Remove Reset RebootStep Va r ia b l e step in the task sequence.
5 Remove the Step 2 group.
6 Remove the RebootStep variable condition present in Step 1 , Step 3 , and
Deploy Operating System groups .
book.book Page 48 Friday, April 13, 2012 9:34 PM