Owner's Manual

25 Using DSDP on Systems Running Configuration Manager 2012
Deleting a Variable Condition
To delete a variable condition :
1
Select the variable condition and click Va r ia b l es  Delete Variable
Condition
. A message that all the attached arrays and disks are deleted is
displayed.
2 Click Yes to delete or No to cancel.
Arrays
Array nodes include both RAID arrays and non-RAID disk groups (indicated
by the different icons for RAID arrays and non-RAID disks). By default, a
non-RAID disk group is created when a controller is created. If the controller
configuration specifies the number of disks required, then the same number
of disks are added to the non-RAID group.
• Arrays are added, modified or deleted depending on the controller
configuration and number of disks available.
• Array elements contain logical drives and physical disks.
Adding a New Array
To add a new array under a variable condition :
1
Select a variable condition and click Arrays  New Array . The Array
Settings
window is displayed.
2 Set the required RAID level from the Desired RAID Level drop-down
menu.
3 Click OK to apply the array, or Cancel to return to Array Builder .
Editing an Array
To edit an array :
1
Select the array and click Arrays  Edit Array . The Array Settings window
is displayed. Here you can select a different RAID level for the array.
2 Click OK to apply the changes, or Cancel to return to Array Builder .
book.book Page 25 Friday, April 13, 2012 9:34 PM