Owner's Manual

Using The Dell Deployment Pack 29
Editing a Variable Condition
1 To edit a variable condition, select the variable condition and click
Variables → Edit Variable Condition .
The
Variable Condition Configuration window displays where you can
make changes to your variable condition.
2 Click OK to apply the variable condition, or Cancel to return to Array
Builder
.
Deleting a Variable Condition
1 To delete a variable condition, select the variable condition and click
Variables → Delete Variable Condition .
A message displays that all the attached arrays and disks will be deleted.
2 Click Yes to delete or No to cancel.
Arrays
Array nodes include both RAID arrays and non-RAID disk groups (indicated
by the different icons for RAID arrays and non-RAID disks). By default,
a non-RAID disk group is created when a controller is created. If the
controller configuration specifies the number of disks required, the same
number of disks will be added to the non-RAID group.
• Arrays can be added, modified or deleted depending on the controller
configuration and number of disks available.
• Array elements contain logical drives and physical disks.
Adding a New Array
1 To add a new array under a variable condition, select a variable condition
and click
Arrays → New Array .
The
Array Settings window displays.
2 Set the required RAID level from the Desired RAID Level drop-down
menu.
3 Click OK to apply the array, or Cancel to return to Array Builder .
book.book Page 29 Thursday, February 5, 2009 5:20 PM