Owner's Manual

To install the Dell Deployment Pack:
1. Download the “Dell_Deployment_Pack_for_ConfigMgr_1.0_Axx.msi”
(where xx is the Dell Deployment Pack revision number) to the
local drive on your system.
2. Double click the .msi package.
3. The “Welcome” screen for Dell Deployment Pack displays.
Click “Next”.
4. The license agreement displays. Select “I accept the terms in the
license agreement.” Click “Next.”
5. The “Setup Type” screen displays. Select the type of installation
on this screen.
NOTE: Dell recommends that you select the “Complete” option.
6. The “Ready to Install the Program” screen displays. Click
“Install.”
7. The “Installing Dell Deployment pack for Configuration Manager
2007” progress screen displays.
8. The “Installation Completed Successfully” screen displays.
Click “Finish.”
The Dell Deployment Pack is installed on your system.
######################################################################
KNOWN ISSUES
######################################################################
Task Sequence Issues/Limitations:
---------------------------------
* It is recommended that you do not move or delete the “Restart in
WinPE,” “SetRebootStep,” “Reboot to PXE/USB,” Second “Format and
Partition” step, “Setup windows and Configmgr,” and “Reset
RebootStep” Custom Action steps in the task sequence.
* The task will fail if the Dell Remote Access Controller
“Virtual Flash” is set to “enabled” on the client machine.
To prevent this, ensure that the “Virtual Flash” is set to
“disabled” when the task is executed on the client machine.
* Installation of Windows Server 2003 operating system will fail
if the mass storage driver to be installed is not selected in the
task Sequence. To do this in the ”Apply Driver Package” step ensure
that you select the Mass Storage Driver that is required for the
operating system installation.
Array Builder Issues/Limitations:
---------------------------------