Setup Guide
Table Of Contents
- 1 Introduction
- 2 iDRAC9 Configuration for RSA SecurID
- 3 RSA SecurID 2FA with Local Users
- 4 RSA SecurID 2FA with Active Directory Users
- 5 RSA SecurID 2FA with Generic LDAP Directory Users
- 6 Troubleshooting RSA SecurID Issues
- 6.1 Misconfiguration or iDRAC Configuration Gets Reset
- 6.2 Datacenter License Expires or Gets Downgraded or Deleted
- 6.3 Authentication Failures without being Prompted for RSA Passcode
- 6.4 Authentication failures with Correct RSA Passcode
- 6.5 Authentication Failures with Correct RSA Passcode due to Timeout
- 6.6 RSA Configuration gets lost after importing Server Configuration Profile
- Appendix A: Configure iDRAC Using RACADM
- Appendix B: References
iDRAC9 Configuration for RSA SecurID
ID 450
• Upload the RSA AM certificate.
• Save the above.
• Ensure that iDRAC can resolve the hostname of the RSA AM server.
Once complete, click “Test Network Connection” to see if iDRAC can communicate with RSA AM server. If
the test fails (See Figure 2.), ensure that all the settings are correct, and the firewall policies have been
appropriately updated. See Troubleshooting
section for more details. For example, if there was a connectivity
issue, test connection may fail as below figure demonstrates.
Test Connection failed due to connectivity issue
A good configuration shows a successful test connection, as shown below.
Test Connection succeeds.