Users Guide
Table Of Contents
- Operating the Monitor
- Operating your monitor
- About your monitor
- Setting up the monitor
- Operating your monitor
- OSD warning messages
- Troubleshooting
- Self-test
- Built-in diagnostics
- Common problems
- Product-specific problems
- Monitor specifications
- Flat panel specifications
- Resolution specifications
- Supported video modes
- FreeSync Graphic Card Support List
- Preset display modes
- Electrical specifications
- Physical characteristics
- Environmental characteristics
- Pin assignments
- Appendix
OSD warning messages | 29
Going into Standby mode...
SE2417HGX
Dell 24 Monitor
If you press any button other than the power button, the following messages will appear
depending on the selected input:
No VGA signal from your device.
?
Press any key on the keyboard or move the mouse to wake it up.
input source.
If there is no display, press the monitor button again to select the correct
Dell 24 Monitor
SE2417HGX
If VGA or HDMI cable is not connected, a floating dialog box as shown below appears. The
monitor will enter the Standby Mode after 5 minutes if left at this state.
No VGA Cable
The display will go into Standby Mode in 4 minutes.
www.dell.com/SE2417HGX
?
Dell 24 Monitor
SE2417HGX
No HDMI 1 Cable
The display will go into Standby Mode in 4 minutes.
www.dell.com/SE2417HGX
?
Dell 24 Monitor
SE2417HGX