Users Guide
Table Of Contents
- Operating the Monitor
- Operating your monitor
- About your monitor
- Setting up the monitor
- Operating your monitor
- OSD warning messages
- Troubleshooting
- Self-test
- Built-in diagnostics
- Common problems
- Product-specific problems
- Monitor specifications
- Flat panel specifications
- Resolution specifications
- Supported video modes
- FreeSync Graphic Card Support List
- Preset display modes
- Electrical specifications
- Physical characteristics
- Environmental characteristics
- Pin assignments
- Appendix
12 | Setting up the monitor
Connecting your monitor
WARNING: Before you perform any of the procedures in this section, follow the
Safety instructions.
NOTE: Do not connect all cables to the computer at the same time. It is recommend to
route the cables through the cable-management slot before you connect them to the
monitor.
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect the VGA/HDMI cable from your monitor to the computer.
Connecting the VGA cable(sold separately)
Connecting the HDMI cable