User's Manual

Troubleshooting 65
Clear Foreign
Config failed!
The Clear Foreign Config
operation has failed with an
error.
Use the controller BIOS
configuration utility to execute this
task. (See the SAS controller user’s
guide for further instructions.) This
is a non-recoverable operation, so be
sure that you want to do this before
continuing.
No Servers
found!
Dell SAS RAID Storage
Manager did not find any
servers to manage.
Uninstall and reinstall the software
application.
Import foreign
configuration
failed!
An error occurred when Dell
SAS RAID Storage Manager
attempted to import a
foreign configuration.
Move the configuration back to the
system where it came from and
verify the configuration there.
Device not
responding!
The device is not
responding to the command
you are sending it.
Re-try the command. Verify that the
hardware is connected and is
configured properly.
This user does
not have
Administrator
right for this
system!
Dell SAS RAID Storage
Manager log-in failed
because the user does not
have administrator rights for
this system. This happens
only when the user is trying
to use Dell SAS RAID
Storage Manager with full
access rights.
Verify that the username has
administrator rights for the local
system (not domain based rights).
Note that you can log in with view
only access if you do not need to
change the configuration.
Drive not
certified
This indicates that the disk
drive was not obtained from
Dell and has not undergone
the testing that is done for
disk drives that Dell
provides.
No action is required. This is a
notification that Dell did not certify
the disk drive.
Table 7-2. Dell SAS RAID Storage Manager Messages (continued)
Message Meaning Action