User's Manual

64 Troubleshooting
Cannot create
Virtual Disk:
Invalid input
parameters for
creating Virtual
Disk.
You have entered some
parameters that are not
valid for the virtual disk.
Be sure that all the virtual disk
parameters are valid, and then retry
creating the virtual disk.
The drive is not
in a state to
perform.
The physical drive does not
support this command. This
might happen when you
send an Undo Prepare for
Removal command to the
wrong physical drive.
This functionality is not supported.
Check the state of the physical
drive.
Save
configuration
failed.
The Save Configuration
command failed while
attempting to save the
configuration to a file.
Be sure that you are saving the
configuration to the correct
location. Be sure there is adequate
free space for the file on the disk. Be
sure you have write permission on
the target.
Reconstruction
on this Volume is
not allowed!
This virtual disk does not
support the Reconstruction
command. The system
hardware is not allowing any
kind of reconstruction.
Verify that the hardware is properly
connected and retry.
Fatal Error:
Cannot connect
to Framework!
A software component of
Dell SAS RAID Storage
Manager cannot establish a
connection to the MSM
framework. The Dell SAS
RAID Storage Manager GUI
is not able to communicate
with the server side software
component.
Confirm that the device driver is
installed and that the system has
been rebooted. If the driver is
present, uninstall and re-install the
application.
Table 7-2. Dell SAS RAID Storage Manager Messages (continued)
Message Meaning Action