User's Manual

Troubleshooting 63
Storelib
Initialization
failed
StoreLib (the library used by
Dell SAS RAID Storage
Manager) could not be
initialized on the system. No
SAS hardware or driver is
present on the system.
Check the knowledgebase articles
on
support.dell.com .
No Storage
Controller
Found!
No controller could be
found on the system. No
SAS hardware or driver is
present on the system.
Verify that the hardware is properly
connected, the SAS controller is
enabled in the system BIOS (if it is
an integrated controller) and the
driver is installed in the system. If
you have just installed the BIOS,
make sure the system has been
rebooted.
Clear
Configuration
failed: Unknown
Exception
The Clear Configuration
command has failed.
Verify that you want to clear the
configuration (this is a non-
recoverable operation). Follow the
instructions in the SAS controller
user’s guide to perform this task
using the controller BIOS utility.
Login failed:
Invalid username
or password!
The username or password
is invalid. User
authentication failed
because the user entered an
invalid user name of
password.
The username and password are set
up by your local system
administrator. Contact your system
administrator to verify the password.
Note that the administrator/root
password is for the local machine,
not a domain based administrator
password.
Auto
Configuration
failed!
Dell SAS RAID Storage
Manager could not proceed
with auto configuration.
This might occur because
the underlying hardware
resources were changed
during the configuration: for
example, a drive was
removed.
Close the Configuration Wizard and
retry. If this happens repeatedly,
verify that the hardware is properly
connected.
Table 7-2. Dell SAS RAID Storage Manager Messages (continued)
Message Meaning Action