Projector User Manual
Table Of Contents
- Dell™ S300w Projector
- Contents
- Your Dell Projector
- Connecting Your Projector
- Using Your Projector
- Turning Your Projector On
- Turning Your Projector Off
- Adjusting the Projected Image
- Adjusting the Projector Focus
- Adjusting Projection Image Size
- Using the Control Panel
- Using the Remote Control
- Installing the Remote Control Batteries
- Operating Range With Remote Control
- Using the On-Screen Display
- Wireless Networking Installation
- Managing the Projector From Web Management
- Make Application Token
- Troubleshooting Your Projector
- Specifications
- Contacting Dell
- Appendix: Glossary
- Index
44 Using Your Projector
SUBNET MASK—Configure the Subnet Mask of the network connection.
G
ATEWAY—Check the Gateway address with your network/system administrator if
you configure it manually.
DNS—Check the DNS Server IP address with your network/system administrator
if you configure it manually.
S
TORE—Press to save the changes made in network configuration settings.
NOTE:
1
Use and button to select IP Address, Subnet Mask, Gateway, DNS and
Store.
2
Press the button to enter IP Address, Subnet Mask, Gateway or DNS to set
the value. (The selected option is highlighted in yellow)
a
Use and button to select the option.
b
Use and button to set the value.
c
After the setup is complete, press the button to exit.
3
After the IP Address, Subnet Mask, Gateway and DNS is set up, select Store
and press the button to store the settings.
WIRELESS—Default is Connect. Select Disconnect to disable the wireless
connection to use LAN networking only.
NOTE: It is recommended to use the default settings for Wireless Connect.
R
ESET—Press to reset network configuration.
INFORMATION
The Information menu displays the current projector settings.