Projector User Manual
Table Of Contents
- Dell™ S300w Projector
- Contents
- Your Dell Projector
- Connecting Your Projector
- Using Your Projector
- Turning Your Projector On
- Turning Your Projector Off
- Adjusting the Projected Image
- Adjusting the Projector Focus
- Adjusting Projection Image Size
- Using the Control Panel
- Using the Remote Control
- Installing the Remote Control Batteries
- Operating Range With Remote Control
- Using the On-Screen Display
- Wireless Networking Installation
- Managing the Projector From Web Management
- Make Application Token
- Troubleshooting Your Projector
- Specifications
- Contacting Dell
- Appendix: Glossary
- Index
Using Your Projector 23
3
To power off the projector quickly, press the Power button and hold for 1 second
while the projector’s cooling fans are still running.
NOTE: Before you turn on the projector again, wait for 60 seconds to allow the
internal temperature to stabilize.
4
Disconnect the power cord from the electrical outlet and the projector.
Adjusting the Projected Image
Raising the Projector Height
1
Raise the projector to the desired display angle, and use the front two tilt
adjustment wheel to fine-tune the display angle.
2
Use the two tilt adjustment wheel to fine-tune the display angle.
Lowering the Projector Height
1
Lower the projector, and use the front two tilt adjustment wheel to fine-tune the
display angle.
1 Front tilt adjustment wheel
(Angle of tilt: -1 to 4 degree)
2 Tilt adjustment wheel
2
1
2
1
1