Deployment Guide

CACStar User Guide Rev A27
Copyright 2017 Digital Imaging Technology Page 7
k. If you wish to enter the gateway, press the F key
again and enter it as you did the IP Address.
l. Press the Exit key twice to return to
Waiting for
Card.
m. To confirm this operation was successful, you can
ping the CACStar at its new IP address from your PC.
Automatic (DHCP) LAN IP Address Configuration:
4. Using the card reader keypad, enable DHCP using the
following steps. See Figure 1 below.
a. Press the F key; the display will say
Information.
b. Press the F key again; the display will say
Configuration.
c. Press the Enter key; the display will show
DHCP
and the current setting. The default is OFF.
d. Press the Enter key; the display will show
F =
Change X = Exit.
e. Press the F key to change the setting from OFF to
ON.
f. Press the Enter key. After about 3 seconds,
CACStar will reboot.
g. After reboot and initialization, press the F key; the
display will say
Information.
h. Press the F key again; the display will say
Configuration.
i. Press the Enter key; the display will show
DHCP
and the current setting.
j. Press the F key again; the display will show
LAN IP
Address and the current setting.