Deployment Guide

CACStar User Guide Rev A27

Initial Setup

1. The printer must be configured to use DHCP which is the

default configuration.

2. Turn the power on. After initialization is complete, the Card

Reader display will say

Waiting For Card. This will take about

1 ½ minutes.

Manual LAN IP Address Configuration:

3. Using the card reader keypad, enter the IP address to be

used to access both the CACStar and the MFD/printer. See

Figure 1 below.

a. Press the F key; the display will say

Information.

b. Press the F key again; the display will say

Configuration.

c. Press the Enter key; the display will show

DHCP and

the current setting. The default is OFF.

d. Press the F key again; the display will show

LAN IP

Address and the current setting.

e. Press the Enter key; the display will show

Enter New

Value.

f. Enter the desired IP Address and press Enter. Use

the IP address you want to use for the host

connection to the MFD/printer.

i. Example: 192.168.1.23 Enter.

g. The display will say

Setting Value for about 5 seconds.

h. Press the F key; the display will say

LAN Subnet Mask

and the current setting.

i. Press the Enter key; the display will show

Enter New

Value.

j. Enter the desired subnet mask like you did the IP

Address.