Product specifications
Loading the Avid Cisco Configuration
88
Restoring From the Avid Software Kit
This section describes how to restore the Avid default Cisco switch configuration to your switch
from the ftp folder on your System Director. The procedure in this section assumes the
following:
• The System Director has been setup and the Avid ISIS software has been installed.
• The switch is connected to the ISIS environment.
• The IP Address on the ISIS 5000 Engines are configured with the default values
(192.168.255.11, 13, 14, 16 for 1 Gb or 192.168.255.21 for 10 Gb)
n
The Avid default configuration files are also located on the Avid ISIS software installer kit
[drive]:\Switch Configuration\ISIS x000\Cisco\. The configuration files are text files that can be
viewed using an application such as WordPad. Copy the switch configuration files to an ftp
directory if you want to access the file using the switch.
To copy the Avid configuration file from the Avid software kit to the switch:
1. From the System Director, use your terminal emulation program or telnet into switch.
2. Type
en
.
3. Copy the new configuration.
t For 4900 type “
copy ftp://administrator:is-admin@192.168.254.11/
ThirdParty/Cisco/4900/Cisco4900_dual2 startup-config
”
t For 4948 type “
copy ftp://administrator:is-admin@192.168.254.21/
ThirdParty/Cisco/4948/Cisco4948e_dual1 startup-config
”
When asked to confirm the file copy type
yes
and press Enter.
If the copy is successful, you see the following on the C4900M switch:
Accessing ftp://administrator:is-admin@10.105.52.2/ThirdParty/Cisco/
4900/Cisco4900_dual2...
Loading ThirdParty/Cisco/4900/Cisco4900_dual2 !
OK - 6396/4096 bytes]
6396 bytes copied in 5.100 secs (1254 bytes/sec)
4. Type
Reload
.
5. You are sometimes prompted to save, type
No
.
6. When asked to reload, type
Yes
.
n
When you perform a reload the switch restarts, you see a Disconnected message, and have to log
back in before continuing.
7. Type
en
.
8. Manually reapply any switch changes you might have applied during your initial switch
setup