Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Connecting the stand
- Using the tilt, swivel, and vertical extension
- Rotating the display
- Configuring the display settings on your computer after rotation
- Operating the monitor webcam
- Connecting your monitor
- Organizing your cables
- Securing your monitor using Kensington lock (optional)
- Removing the monitor stand
- Wall mounting (optional)
- Operating the monitor
- Troubleshooting
- Appendix
22 | About your monitor
Universal Serial Bus (USB)
This section provides information about the USB ports available on your monitor.
NOTE: Up to 2 A on USB downstream port (port with battery icon) with
BC 1.2 compliance devices; up to 0.9 A on the other 1 USB downstream ports.
Your computer has the following USB ports:
• 1 upstream - at rear.
• 2 downstream - 1 at bottom, 1 at rear.
NOTE: The monitor’s USB ports work only when the monitor is on or when the
monitor is on, in Standby Mode. When the monitor is on, in Standby Mode, if the
USB cable (C to C), is plugged in, the USB ports can work normally. Otherwise,
follow the OSD setting of Other USB Charging, if the setting is “On in Standby
Mode” then USB work normally, otherwise USB is disabled. If you turn off the
monitor and then turn it on, the attached peripherals may take a few seconds to
resume normal functionality.
Transfer speed Data rate Maximum power consumption (each port)
super speed 5 Gbps 4.5 W
hi speed 480 Mbps 2.5 W
full speed 12 Mbps 2.5 W
USB downstreamport
Pin number Signal name
1 VBUS
2 D-
3 D+
4 GND
5 StdA_SSRX-
6 StdA_SSRX+
7 GND_DRAIN
8 StdA_SSTX-
9 StdA_SSTX+
Shell Shield