Owner's Manual

In the firmware image file folder, if there is no firmware image file for a specific RAC type, then the
corresponding option is disabled and is not available for selection. For example, if the firmware image file is
not available for DRAC 4, then you cannot select the DRAC4 option.
4. Click Update Firmware.
If the firmware update is successful, the Status column displays the following messages in a sequence for each IP
address:
– Preparing Firmware Update
– Transferring Firmware Image — This message is displayed only when the firmware image files are used
from your local directory location.
– Updating Firmware
– Restarting
– Firmware Update Success
If the firmware update is not complete, the Status column displays one of the following messages for the IP
address(es):
– Failed to initiate
– Insufficient Privileges
– Unable to find Firmware image
– Firmware Update Failed
For information on the reasons for failure and the solution, see Troubleshooting and Frequently Asked Questions.
After the firmware is updated for the selected RACs, the "Firmware Update Completed" message is displayed.
5. Click OK to complete the firmware update for the selected RACs.
16