Owner's Manual

34 Troubleshooting and Frequently Asked Questions
Firmware update failed with the message Insufficient Privileges.
The user name and password provided during RAC verification do not have
RAC configuration privileges.
Firmware update failed with the message Failed to initiate.
The RAC firmware is in an undefined state or is not accessible remotely.
Remove and plug the power cord back on your system and ensure that the
RAC is accessible before performing the firmware update using DRACT.
Firmware update fails with the message Firmware update failed.
The controller was in an undefined state or there was a known firmware
update issue on the particular firmware version. For the solution, see the
readme file for the specific firmware version before updating the firmware
again.
AD update fails with the message Failed to Update Active Directory.
Ensure that you have followed the AD setup steps documented in the
appropriate RAC user guide to set up the AD server to enable AD
authentication to the RAC.
Ensure that you provide the AD credentials that have configuration privilege
on the domain controller.
Standard schema, extended schema, or AD schema disabled failed with the
message Insufficient Privileges.
The user name and password provided to verify the RAC IP addresses do not
have configuration privileges on the RAC.
Standard schema, extended schema, or AD schema disabled fail with the message
Configuration Failed.
The RAC was in an undefined state or there was a known configuration
update issue on a particular firmware version. For the solution, see the
readme file for the specific firmware version before updating the firmware
again.