Release Notes

Systems
affected:
● PowerEdge R6525: Impacted slots are 1, and 2
● PowerEdge R7525: Impacted slots are 1, 2, 3, 6, 4, 5, 7, and 8
Tracking number: 148546
iscsiadm output displays STATIC in the
iface.bootproto field when the network interface is
configured to DHCP
Description:
When the system is booting from iSCSI with the Emulex OneConnect device that is configured with
DHCP IP, the iface.bootproto field is listed as STATIC in the command iscsiadm -m fw output.
There is no functionality loss.
Applies to:
Red Hat Enterprise Linux 8.1 and later
Cause: Not available
Workaround: Not available
Systems
affected:
Dell EMC PowerEdge yx3x servers that support Emulex OneConnect
Tracking number: 147877
Red Hat Enterprise Linux Version 8 installation wizard
creates a duplicate bonding interface
Description:
During Red Hat Enterprise Linux Version 8.1 installation, after creating a bonding and VLAN interface with
the bonding interface as the parent interface, the system automatically creates a duplicate bonding,
VLAN, and virtual network interfaces named as None. Later, the system encounters an unknown error,
and further network configurations are not allowed. The duplicate entries are created when the bonding
interface or VLAN interface does not obtain an IP address. You can resume the operating system
installation by restarting anaconda service, systemctl restart anaconda in the shell.
Applies to: Red Hat Enterprise Linux 8.1
Cause: Not available
Workaround: Not available
Systems
affected:
Dell EMC PowerEdge yx4x and yx5x servers
Tracking number: 128135
When system reboots, system stops responding at
the end of the reboot process
Description:
When the system reboots, system stops responding at the end of the reboot process. When the system is
in this state, it does not respond to keyboard or mouse device and iDRAC virtual console displays the No
signal message.
Applies to:
Red Hat Enterprise Linux 8
Cause: Not available
20 Known issues