Technical Guide

Configurations Processor Fan type HSK type Air
shroud
DIMM
blank
Processor
blank
Fan
counts
Fan blank
SM
Config
Rear Wall
Config
SKU
#3 and
replace by
HDD blank
x2 )
2.5-inch
SAS/SATA
x6 (2.5-
inch SAS/
SATA x10
config
remove
HDD #6 ~
#9 and
replace by
SM blank
x2 )
Any (W/O
Rear HDD)
220 W
<TDP<=
270 W
HPR Gold
Fan (VHP)
HPR HS
2.5-inch
NVMe x4
(2.5-inch
NVMe x10
config
remove
HDD #5 ~
#9 and
replace by
SM blank
x3 )
NOT
Support
PCIe Slot
2 Only
220 W
<TDP<=
270 W
HPR Gold
Fan (VHP)
HPR HS
Thermal Solution Configuration
Table 36. 8 x 2.5-inch SAS/SATA and 4x3.5-inch and No BP storage configuration
Dell EMC PowerEdge Server
Standard Operating Support
(ASHRAE A2 compliant) All
options supported unless
otherwise noted.
Dell EMC PowerEdge Server
Extended Inletient 40 ° C Operating Support
(ASHRAE A3 compliant)
Dell EMC PowerEdge Server
Extended Inletient 45 ° C
Operating Support (ASHRAE
A4 compliant)
● HPR Silver Fan is required for
processor TDP >165 W
● HPR Silver Fan is required for
config with RM
● 8 x 2.5-inch SAS/SATA only
support processor TDP <=220
W
● 4 x 3.5-inch config processor
TDP >220 W SM only support
2 x 3.5-inch at HDD#0, HDD#1
and HDD Blank x 2 are required
at HDD#2 and HDD#3
● 4 x 3.5-inch config processor
TDP>220W, RIO support PCIe1
and OCP only. (No BOSS1.0,
PCIe2&PCIe3)
● The Following OCP3.0 NIC
only support optic cable with
● Not support processor TDP > 150 W
● Not support BOSS M.2 Module
● Not support Non-Dell qualified peripheral cards
and Channel devices (FW) cards
● Not support NIC consuming power >= 25W. Ex:
CX6 card
● Not Support Config with RM
● Not support OCP transfer rate >25G or cooling
tier > 10
● Optic Cable with spec 85C is required
●
Two PSUs are required. System performance may
be reduced in the event of a PSU failure
A4 environment not Support
54 Appendix A: Additional specifications