Quick Start Guide
Table Of Contents
- Dell EMC PowerEdge R650xs Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge R650xs system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Air shroud
- Cooling fans
- Intrusion switch module
- Drives
- Optional optical drive
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Drive cage
- Optional serial COM port
- MicroSD card
- Optional BOSS S1 card
- Optional IDSDM module
- Optional OCP card
- Front mounting front PERC module
- System battery
- Optional internal USB card
- VGA module
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Expansion card installation guidelines
Figure 64. Expansion card slot connectors
The following table describes the expansion card riser configurations:
Configurations
Expansion card
risers
PCIe Slots Controlling
processor
Height Length Slot width
Config0. with 1x
LP
R1 + rear 2
drives
1 Processor 1 Low Profile Half length x16
Config1. with 3x
LP
R1 1 Processor 1 Low Profile Half length x16
R2a 2 and 3 Processor 2 Low Profile Half length x8 + x8
Config2. with 2x
LP
R1 1 Processor 1 Low Profile Half length x16
R2b (SNAPI) 3 Processor 1 and
2
Low Profile Half length x16
Config3. with 2x
LP
R1 1 Processor 1 Low Profile Half length x16
R2c 3 Processor 2 Low Profile Half length x16
Config4. with 1x
LP
R1 1 Processor 1 Low Profile Half length x16
Config5. with 0x
LP
NA NA NA NA NA NA
Config6. with 1x
LP
R2c 3 Processor 2 Low Profile Half length x16
Installing and removing system components 71