Product Data Sheet / Brochure

**** HDD Blank is required for empty HDD slot.
Table 23. Label reference
Label Description
LP Low Profile
HPR (Gold) High performance (gold grade)
HPR (Silver) High Performance (silver grade)
HSK Heat sink
Other Thermal restrictions
● 10 x 2.5-inch NVMe configuration requires HPR (Gold) fan. 7 fans are required for dual processor configuration.
● DIMM blank is not required.
● Processor blank is required for single processor configuration.
● Two fan blanks are required to be installed on fan slot 1 and fan slot 2 for 5 fans configuration.
Table 24. Thermal restriction matrix for processor and configurations
Parameters Configurations
Front storage 2 x 3.5-inch SAS/SATA
configuration
4 x 2.5-inch NVMe
configuration
6 x 3.5-inch SAS/SATA
configuration
Fan type and quantity HPR (Silver) fan x 7 HPR (Gold) fan x 7 HPR (Gold) fan x 7
Rear configuration OCP, PCIe slot 1 only OCP, BOSS, PCIe slot1 and
slot 3
OCP, BOSS, PCIe slot1, slot 2 and
slot 3
Processor
TDP
250 W HPR HSK HPR HSK HPR HSK
270 W HPR HSK HPR HSK HPR HSK
Maximum Ambient
Temperature
35°C 35°C 35°C
NOTE: DIMM blank is not required.
Thermal Restriction for ASHRAE A2/A3/A4
Table 25. 4 x3 .5-inch SAS/SATA and 8 x 2.5-inch SAS/SATA and No BP Configuration
Dell EMC PowerEdge Server
Standard Operating Support
(ASHRAE A2 compliant) All options
supported unless otherwise noted.
Dell EMC PowerEdge Server
Extended Inletient 40° C Operating
Support (ASHRAE A3 compliant)
Dell EMC PowerEdge Server
Extended Inletient 45° C Operating
Support (ASHRAE A4 compliant)
● HPR Gold Fan is required for
Processor TDP >165 W
● HPR Gold Fan is required for with
RM configuration
● 10 x 2.5-inch SAS/SATA config
Processor TDP >220 W SM only
support 6 x 2.5-inch SAS/SATA at
HDD#0~ HDD#5 and SM Blank x 2
are required at HDD#6 ~HDD#9
● With RM Config do not support
Processor TDP >220 W
● Not support processor TDP > 150 W
● Not support BOSS M.2 Module
● Not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Not support NIC consuming power
>= 25 W.
● Not Support Config with RM
● Not support OCP transfer rate >25 G
or cooling tier > 10
●
Optic Cable with spec 85°C is
required.
A4 environment not support
Technical specifications 15