Important information

Important Information 25
I do not know the
name of my
PowerEdge storage
server.
The name of the
PowerEdge storage
server can be viewed in
My Network Places.
Double-click My Network Places
on the desktop of the client
system and look for PowerEdge
storage server name. The default
name for the PowerEdge storage
server is
DELL xxxxxxx , where
xxxxxx is the system's service
tag. For example, if the service
tag is 1234567, the system name
is
DELL1234567. You can find
the service tag on the top cover of
the PowerEdge storage server.
After using Remote
Desktop to connect to
my PowerEdge storage
server, I am unable to
type using my native
language.
The PowerEdge
storage server is set to
English, the default
language.
Most character sets are installed
by default on your system. If
your language character set is
not installed, you can install
your native language character
set from the Multilingual
Support media that was shipped
with your system.
The PowerEdge
storage server is
attached to a DHCP
network, but I cannot
connect to it through
the MMC.
The DHCP server may
have issued a new
DHCP address to the
PowerEdge storage
server.
If the PowerEdge storage server
has been powered down for a
period of time predetermined by
the DHCP server, the PowerEdge
storage server acquires a new
DHCP address from that server.
The DHCP server may not have
yet replicated the new address
with the PowerEdge storage
server name.
Wait approximately 15 minutes
for the address to be replicated
and then try connecting again or
try connecting to the PowerEdge
storage server again using the
IP address.
Table 1-7. Troubleshooting Matrix (continued)
Issue Possible Cause Resolution