Users Guide

3–Adapterverwaltungsanwendungen
Allgemeine Verwaltung mit QConvergeConsole
58
CU0354602-01 M
IPv6_DAD_Count : 1
IPv6_Router_Advertised_MTU : 0(*)
IPv4_Address_State : Valid(*)
IPv6_Link_Loc_Address_State : Invalid(*)
IPv6_Address0_State : Invalid(*)
IPv6_Address1_State : Invalid(*)
IPv6_Default_Router_State : No router(*)
IPv6_MCast_Listnr_Disco_Enable : off
ACB_Version : 2(*)
AFW_Serlz_Task_Mngmt : off
Large_Frames : off
*** Displaying IPv6 Settings inst=0 ***
IPv6_Addr_Local_link : fe80::
IPv6_Addr_Routable0 : ::
IPv6_Addr_Routable1 : ::
Default_IPv6_Router : ::
IPv6_Port : 3260
IPv6_Gratuitious_Neighbor_Ad_Enable : off
IPv6_Redirect_Enable : off
*** Displaying IPv6 TCP Settings inst=0 ***
IPv6_Nagle : off
IPV6_TCP_Timer_Scale : 3(*)
IPv6_TCP_Time_Stamp : on
*** Displaying Remaining parameters inst=0 ***
ACB_Supported : on(*)
Values noted with (*) are read only.
Ändern von iSCSI-Parametern auf Portebene
Mithilfe des –n-Befehls können Sie iSCSI-Parameter auf Portebene ändern.
Befehlszeilenoptionen:
-n <hba_port_inst> <config_name|config_alias> <value>
<config_name|config_alias> <value>

Beispiel:
Im folgenden Beispiel ist die HBA-Portinstanz 0. Mit der Parameteränderung
sollen iSCSI-Header Digests aktiviert werden.
$qaucli -pr iscsi -n 0 iSCSI_Header_Digests on
Oder:
$qaucli -iscsi -n 0 iSCSI_Header_Digests on
Port Parameters:
The following table lists the parameters that may be configured using
the -n option in non-interactive mode.

Full Parameter Name Alias Name Allowable Values
------------------- ---------- ---------------- 
AFW_Device_Timeouts AFWDT on or off 
AFW_Delayed_Ack AFDACK on or off 
AFW_AutoConnect AFWC on or off 