Users Guide

3–Fibre Channel Configuration
Configuring and Verifying FA-BLD
73 CU0354604-00 R
Figure 3-24 shows an example.
Figure 3-24. Enabling Fabric-Assigned Boot LUN
Configuring the Adapter and Boot Devices with QConvergeConsole CLI
To configure adapter and boot devices:
1. In QConvergeConsole CLI, navigate to Adapter Configuration and then
select HBA Parameters.
2. Enter the port number.
3. Select Configure HBA Parameters.
4. Select Enable BIOS and set it to Enable.
5. In the Adapter Configuration, select Boot Device Configuration.
6. Enter the port number.
7. Select Configure Boot Device(s).
8. Set the Enable Fabric Assign Boot LUN to Enable.
9. Select Commit Changes.