Users Guide

3–Fibre Channel Configuration
Configuring the UEFI Driver
56 CU0354604-00 R
Configuring the UEFI Driver
This section provides information on configuring the unified extensible firmware
interface (UEFI) driver contained in the multiboot image. UEFI 2.x systems use a
human interface infrastructure (HII) to configure motherboard devices and plug-in
adapters. QLogic Fibre Channel Adapters use an HII to configure adapter
parameters and boot-from-SAN settings.
To configure the UEFI driver for Dell:
1. During system boot, press the key corresponding to your platform.
2. On the Dell System Setup window, select Device Settings, and then press
the ENTER key.
The Device Settings window opens and lists the devices installed in the
system. Each listed device supports the HII. QLogic devices have one
device settings entry per port. Each entry contains the adapter name and
WWPN of the port. Figure 3-11 shows an example of the System Setup
window for Device Settings.
Figure 3-11. Dell System Setup: Device Settings