Users Guide

3–Fibre Channel Configuration
Configuring Selective LUNs
54 CU0354604-00 R
Configuring Fibre Channel Driver Parameters with
Noninteractive QConvergeConsole CLI
To configure driver settings, issue the following command:
# qaucli -pr fc -fs (<hba instance> | <hba wwpn>) {(<param name> |
<param alias>) <param value>}
Where:
For more information, refer to the section about the Fibre Channel noninteractive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).
Configuring Fibre Channel Driver Parameters with
QConvergeConsole VMware vCenter Server Plug-in
For details on how to configure the Fibre Channel driver parameters using the
QConvergeConsole plug-in, see the User’s Guide—QConvergeConsole Plug-ins
for VMware vSphere (part number SN0054677-00).
Configuring Selective LUNs
The QConvergeConsole GUI cannot be used for configuring selective LUNs.
To configure selective LUNs with the interactive QConvergeConsole CLI, refer to
the section about the Fibre Channel interactive commands in the User’s
Guide—QConvergeConsole CLI (part number SN0054667-00).
To configure selective LUNs with the noninteractive QConvergeConsole CLI, refer
to the section about the Fibre Channel noninteractive commands in the User’s
Guide—QConvergeConsole CLI (part number SN0054667-00).
hba instance = Adapter number (use the -g command to find)
hba wwpn = Worldwide port name of the adapter
param name = Name of the parameter
param alias = Alias of the parameter
param value = New value of the parameter