Users Guide

3–Fibre Channel Configuration
Configuring Fibre Channel Driver Parameters
53 CU0354604-00 R
Configuring Fibre Channel Driver Parameters
Use QConvergeConsole GUI, CLI, or VMware plug-in to configure Fibre Channel
driver parameters:
 Configuring Fibre Channel Driver Parameters with QConvergeConsole GUI
 Configuring Fibre Channel Driver Parameters with Interactive
QConvergeConsole CLI
 Configuring Fibre Channel Driver Parameters with Noninteractive
QConvergeConsole CLI
 Configuring Fibre Channel Driver Parameters with QConvergeConsole
VMware vCenter Server Plug-in
Configuring Fibre Channel Driver Parameters with
QConvergeConsole GUI
Refer to the topics about HBA parameters and viewing or modifying port
parameters in the QConvergeConsole Help for information.
Configuring Fibre Channel Driver Parameters with Interactive
QConvergeConsole CLI
To configure Fibre Channel driver parameters using interactive
QConvergeConsole CLI:
1. On the Fibre Channel Adapter Configuration menu, select HBA
Parameters.
2. On the port menu, select a port to open the HBA Parameters menu.
3. On the HBA Parameters menu, select Configure HBA Parameters to
open the Configure Parameters menu with options to configure connection
options, data rate, frame size, hard loop ID, loop reset delay, BIOS, Fibre
Channel tape support, operation mode, interrupt delay timer, login retry
count, port down retry count, LIP full login, link down time-out, target reset,
LUNS per target, and receive out-of-order frames.
For more information, refer to the section about the Fibre Channel interactive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).