Users Guide

Doc No. TD-000971 Rev. 1
January 29, 2021 Page 145 Copyright © 2021 Marvell
4 QCS CLI Usage
This chapter provides the following information about using QLogic Control Suite
CLI to perform tasks:
 Using Interactive Mode
 Performing Management Tasks
Using Interactive Mode
To start QLogic Control Suite CLI in interactive mode, issue the QCSCLI
command without additional parameters.
For example:
QCSCLI
To exit from QLogic Control Suite CLI interactive mode, issue the q command.
For example:
q
Performing Management Tasks
This section provides methods for performing some common management tasks
using QCS CLI. The methods for performing the task in the CLI mode
(noninteractive), interactive mode, or both, are included as appropriate.
 Listing Target Adapters of Different Views in CLI Mode
 Obtaining Context Help for each Command
 Switching Between Different Views of Target Adapters
 Selecting a Target for the Command to Operate On
 Selecting a Target in Interactive Mode
 Getting Information for a Selected Target
 Configuring Advanced Parameters for a Selected Target
 Displaying Licenses for a Selected Target