Users Guide

Doc No. TD-000971 Rev. 1
January 29, 2021 Page x Copyright © 2021 Marvell
Preface
This guide describes how to install, start, and use QLogic
®
Control Suite™ CLI, a
primary CLI for configuring Marvell FastLinQ 41000/45000 Series Adapters and
adapters based on 578xx controllers. QLogic Control Suite CLI can also be used
to list and view information about the legacy network adapters (that is, adapters
not based on the 578xx/41000/45000 Series Controllers).
Intended Audience
This guide is designed for users who are managing Marvell FastLinQ
41000/45000 Series Adapters and adapters based on 578xx controllers using
QLogic Control Suite CLI.
What Is in This Guide
This preface specifies the intended audience, lists related documents, explains
typographic conventions used in this guide, and provides technical support
information.
The remainder of the guide is organized into the following chapters and
appendices:
 Chapter 1 Introduction describes the components, architecture, and
structure of QLogic Control Suite CLI.
 Chapter 2 Installing and Launching lists the QLogic Control Suite CLI
requirements, package contents, and supported OS and adapters. It
provides QCS CLI and management agent installation instructions, as well
as how to launch the CLI and add a host.
 Chapter 3 QCS CLI Commands provides details about commands in QLogic
Control Suite CLI, including a description, syntax, keywords, and examples
for each command.
 Chapter 4 QCS CLI Usage covers using interactive mode and provides
task-oriented information using QLogic Control Suite CLI.
NOTE
Throughout this guide, the QLogic Control Suite CLI management tool is
also referred to as QCS CLI.