Users Guide

4–Using the vCenter Server Plug-in
Managing Converged Network Adapters
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 69 Copyright © 2021 Marvell
If a target is attached to the function, the content pane also contains a table that
lists how many of each of the following errors have occurred for the target:
 Link Failure
 Sync Loss
 Signal Loss
 Invalid CRC
 Seq Proto Error
 Invalid Trans Word
Diagnostics Tests—FCoE Function
If the Diagnostics button is selected, the content pane appears as shown in
Figure 4-43.
Figure 4-43. Converged Network Adapter FCoE Function—Diagnostic Tests
In the content pane, select the type of diagnostic test to perform: Loopback Test,
Read-Write Buffer Test, FC Ping, CT Ping, CT FC Trace Route, or Firmware
Debug Dump. Then specify the following information:
Loopback Test and Read-Write Buffer Test
 Data Pattern: Select the type of data pattern to use in the test. Or, type the
pattern to use into the boxes provided.
 Number of test(s): Specify the quantity of tests to run (1–65,536).
 Test Increment: Specify the test increment (1–65,536).
 Data Size (Bytes): Specify the data size in bytes.