Users Guide

4–Using the vCenter Server Plug-in
Managing Converged Network Adapters
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 65 Copyright © 2021 Marvell
The content pane contains the following:
 Current Function Type: The selected function’s current type—Fibre
Channel (FCoE).
 New Function Type: To change the function type from Fibre Channel to
Ethernet NIC or Disabled, select the appropriate box and click Save
Configuration. The new type does not take effect until the next system
reboot.
Boot Configuration—FCoE Function
If the Boot button is selected, the content pane appears as shown in Figure 4-39.
Figure 4-39. Converged Network Adapter FCoE Function—Boot Configuration
The content pane contains the following configurable parameters:
 Enable boot from the port: Select the check box to enable booting from
the selected port, or clear the check box to disable booting from the port.
 Boot from the selected device(s): Select the check box to allow booting
from a boot device that you specify, or clear the check box to disable this
feature.
The following options are available only if Boot from the selected device(s) is
selected:
 Primary Boot: Specify the primary boot device by selecting its worldwide
name in Target WWN, and then select the device’s LUN ID in LUN ID.
 Alternate Boot 1/2/3: Specify three alternate boot devices by selecting their
worldwide names in Target WWN, and their LUN IDs in LUN ID.
To save your changes, click Save Configuration.