Users Guide

4–Using the vCenter Server Plug-in
Managing Converged Network Adapters
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 63 Copyright © 2021 Marvell
Managing FCoE Functions on a Converged Network Adapter
To manage an FCoE function on a Converged Network Adapter port, select the
FCoE function in the system tree. The Adapter Management window then
appears as shown in Figure 4-36.
Figure 4-36. Adapter Management Window—FCoE Function
The identifying information at the top of the content pane includes the following:
 Function Type: (FCoE)
 Link Status: (Up or Down)
 PCI Function Number: For Port 1: 2, 4, or 6. For Port 2: 3, 5, or 7
 MAC Address: MAC address of the PCI function
 Device Name: Device name
 Link Speed: The speed of the link—10Gb
Below the identifying information is a row of buttons, as shown in Figure 4-37:
Figure 4-37. Converged Network Adapter FCoE Function—Information Selection
These buttons let you select the information to manage for the FCoE function:
 NPAR—NIC partitioning configuration
 Boot—Boot device configuration
 Parameters—Firmware parameters
 Transceiver—Transceiver information
 Statistics—Statistics information
 Diagnostics—Diagnostic tests