Users Guide

4–Using the vCenter Server Plug-in
Managing Fibre Channel Adapters
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 40 Copyright © 2021 Marvell
 Ext. Identifier: Additional information about the transceiver
 Part Number: Transceiver part number
 Speed: Transceiver transmission speed
 Connector: Transceiver external optical or electrical cable type
 Serial Number: Transceiver serial number
 Revision: Vendor revision level
 QLogic SFP installed: Yes, if a QLogic SFP is installed; No, if an
unsupported SFP is installed, or no SFP is installed.
A table at the bottom of the content pane displays information for the following
transceiver characteristics: Temperature, Voltage, Tx Bias, Tx Power, and Rx
Power. The information displayed for each of these characteristics includes:
 Value: Current value
 Status: Current status
 High Alarm: If a datum exceeds this value, the conditions are likely to cause
an inoperable link and require immediate action.
 High Warning, Low Warning: Warnings indicate conditions outside the
normally guaranteed bounds, but are not necessarily causes for immediate
link failures.
 Low Alarm: If a datum is less than this value, the conditions are likely to
cause an inoperable link and require immediate action.