Users Guide

11–Managing Marvell 578xx and 41000 Series Adapters
Configuring Port Boot Options
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 238 Copyright © 2021 Marvell
Figure 11-42. Boot Configuration – FCoE Boot Page (HTML5 based vSphere Client
Plug-in)
Configuring General Parameters
To configure the general parameters:
1. Select the appropriate port in the QConvergeConsole system tree.
2. Select the Manage tab.
3. On the Manage page, click the QConvergeConsole tab.
4. On the QConvergeConsole page, click the Boot Configuration tab.
5. On the Boot Configuration page, click FCoE Boot as shown in Figure 11-42.
6. Click Edit.
7. Complete the following in the Update FCoE Boot Configuration dialog box,
as shown in Figure 11-43 and Figure 11-44:
a. Click General Parameters.
b. Select the Boot to FCoE target
1
check box to enable boot to FCoE
target, or clear the check box to disable it.
c. Select the Target as First HDD
1
check box to enable target as first
HDD, or clear the check box to disable it.
d. Set a value (from 0 to 255) in the Link Up Delay Time box.
1
This feature is not applicable to 41000 Series Adapters.