Users Guide

11–Managing Marvell 578xx and 41000 Series Adapters
Configuring Port Boot Options
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 236 Copyright © 2021 Marvell
To configure the MPIO parameters:
1. Select the appropriate port in the QConvergeConsole system tree.
2. Select the Manage tab.
3. On the Manage page, click the QConvergeConsole tab.
4. On the QConvergeConsole page, click the Boot Configuration tab, and
then click iSCSI Boot (see Figure 11-31 on page 230).
5. Click Edit.
6. Complete the following in the Update iSCSI Boot Configuration dialog box,
as shown in Figure 11-39 and Figure 11-40:
a. Click MPIO Parameters.
b. Select the Enable MPIO check box to enable the MPIO, or clear the
check box to disable the MPIO.
c. Select a MAC Address from the adapter (or select None) for the
Secondary Device.
d. Select the Use Independent Target Portal check box to enable the
independent target portal, or clear the check box to disable the
independent target portal.
e. Select the Use Independent Target Name check box to enable the
independent target name, or clear the check box to disable the
independent target name.
7. Click OK or Finish.
Figure 11-39. Update iSCSI Boot Configuration, MPIO Parameters
(vSphere Web Client Plug-in)