Users Guide

11–Managing Marvell 578xx and 41000 Series Adapters
Configuring Port Boot Options
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 231 Copyright © 2021 Marvell
f. Select the CHAP Authentication check box to enable CHAP
authentication, or clear the check box to disable it.
g. Select Enabled or Disabled for the Boot to iSCSI target
1
option.
h. Type the DHCP vendor ID in the DHCP Vendor ID box.
i. Set a value (from 0 to 255) in the Link Up Delay Time box.
j. Select the Use TCP Timestamp
1
check box to enable TCP time
stamp, or clear the check box to disable it.
k. Select the Target as First HDD
1
check box to enable target as first
HDD, or clear the check box to disable it.
l. Set a value (from 0 to 60) in the LUN Busy Retry Count
1
box.
m. Select IPv4 or IPv6 as the IP Version.
n. Select the HBA Boot Mode
1
check box to enable HBA boot mode, or
clear the check box to disable it.
8. Click OK.
Figure 11-32 shows the Update iSCSI Boot Configuration, General Parameters
for 578xx Series Adapters. Figure 11-33 shows the Update iSCSI Boot
Configuration, General Parameters for 41000 Series Adapters. Figure 11-34
shows the Update iSCSI Boot Configuration, General Parameters in the HTML5
based vSphere Client Plug-in.
Figure 11-32. Update iSCSI Boot Configuration, General Parameters
for 578xx Series Adapters
1
This feature is not applicable to 41000 Series Adapters.