Users Guide

11–Managing Marvell 578xx and 41000 Series Adapters
Configuring Port Boot Options
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 229 Copyright © 2021 Marvell
Configuring iSCSI Boot
This section describes how to set up the iSCSI boot configuration in the following
four sections:
 Configuring General Parameters
 Configuring Initiator Parameters
 Configuring Primary and Secondary Target Parameters
 Configuring MPIO Parameters
Configuring General Parameters
To configure the general parameters:
1. Select the appropriate port in the QConvergeConsole system tree.
2. Select the Manage tab.
3. On the Manage page, click the QConvergeConsole tab.
4. On the QConvergeConsole page, click the Boot Configuration tab.
5. On the Boot Configuration page, click iSCSI Boot as shown in Figure 11-30
and Figure 11-31.
Figure 11-30. iSCSI Boot Configuration in the vSphere Web Client Plug-in