Users Guide

Table Of Contents

10–Using the vSphere Web Client Plug-in

Managing FCoE Functions

Doc. No. TD-000965 Rev. 1

Ping Tests

To perform an FCoE function ping test:

1. In the host system tree, expand an FCoE adapter node to view the ports,

and then select a port.

2. In the content pane, click the Diagnostics tab to open the Diagnostic Tests

page.

3. In the Ping Tests table, select a target. To choose multiple targets, hold

down the CTRL key while you click additional targets.

4. To start a test, click either Start FC Ping, Start CT Ping, or Start CT FC

Trace Route.

5. In the test dialog box, specify the quantity of tests to run, and then click OK.

6. Observe the test results. The result for each test appears in the Ping Tests

table (Figure 10-44).

Figure 10-44. FCoE Ping Test Results

NOTE

To successfully run a CT Ping or a CT FC Trace Route ping test, the

fabric must contain a Brocade switch.