Users Guide

10–Using the vSphere Web Client Plug-in
Managing FCoE Functions
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 180 Copyright © 2021 Marvell
6. In the Loopback Test dialog box, specify values for the following test
parameters, and then click OK:
 Data Pattern
 Number of tests
 Test Increment
 Data Size (Bytes)
 On Error
 Test continuously
7. Observe the test results.
Read-Write Buffer Test
To perform a read-write buffer test:
1. Install a loopback plug in the selected port.
2. In the host system tree, expand an FCoE port node to view the functions.
3. Select a function.
4. In the content pane, click the Diagnostics tab to open the Diagnostic Tests
page.
5. Click Read-Write Buffer Test.
6. In the Read-Write Buffer Test dialog box, enter values for the following test
parameters, and then click OK:
 Data Pattern
 Number of tests
 Test Increment
 Data Size (Bytes)
 On Error
 Test continuously
7. Observe the test results.
Retrieve Firmware Debug
To retrieve the FCoE function firmware debug dump:
1. Install a loopback plug in the selected port.
2. In the host system tree, expand an FCoE port node to view the functions.
3. Select a function.
4. In the content pane, click the Diagnostics tab to open the Diagnostic Tests
page.
5. To retrieve the debug.bin file, click Retrieve Firmware Debug.