Users Guide

5–Managing Marvell 578xx and 41000 Series Adapters
Running Adapter Port Diagnostics
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 109 Copyright © 2021 Marvell
On the Link Settings page, the adapter port can be configured for Smart AutoNeg
or Advanced Link Settings. Selecting Advanced Link Settings allows you to
configure the speed and FEC modes. The available speeds vary based on the
speed capability of the adapter.
The Smart AutoNeg option may also appear in the MBA Boot Configuration list
of available speeds. Changing the speed on the Link Settings page also changes
the speed in the MBA Boot Configuration list.
Running Adapter Port Diagnostics
This section describes how to run a port diagnostic test.
To run a port diagnostic test:
1. In the QConvergeConsole system tree, select an adapter, and then select
the appropriate port.
2. In the content pane on the right, click Diagnostics.
3. Specify the test type to run by selecting the appropriate Test check box or
boxes, as shown in Figure 5-14:
 Control Registers
 Internal Memory
 EEPROM
 Interrupt
 Loopback MAC
1
 Loopback PHY
 LED
Figure 5-14. Diagnostics Pane
1
This option does not apply to 41000 Series Adapters.