Users Guide

5–Managing Marvell 578xx and 41000 Series Adapters
Configuring Port Boot Options
Doc. No. TD-000965 Rev. 1
January 21, 2021 Page 104 Copyright © 2021 Marvell
j. Select the Target as First HDD
1
check box to enable the target as first
HDD, or clear the check box to disable it.
k. Set a value (from 0 to 60) in the LUN Busy Retry Count
1
box.
l. Select IPv4 or IPv6 for the IP Version option.
m. Select the HBA Boot Mode
1
check box to enable the HBA boot mode
or clear the check box to disable it.
5. Click Save.
Figure 5-11 on page 106 shows the Configure General Parameters section in
the iSCSI Boot Configuration window.
Configuring Initiator Parameters
To configure the iSCSI initiator parameters:
1. In the QConvergeConsole system tree, select an adapter, and then select
the appropriate port.
2. In the content pane on the right, click Boot Configuration.
3. Click the iSCSI Boot button.
4. Under Configure Initiator Parameters, complete the following:
a. Type the IP address in the IP Address box.
b. Type the subnet mask in the Subnet Mask box.
c. Type the default gateway in the Default gateway box.
d. Type the primary DNS in the Primary DNS box.
e. Type the secondary DNS in the Secondary DNS box.
f. Type the iSCSI name in the iSCSI Name box.
g. Type the CHAP ID in the CHAP ID box.
h. Type the CHAP secret key in the CHAP Secret box.
5. Click Save.
Figure 5-11 on page 106 shows the Configure Initiator Parameters section in the
iSCSI Boot Configuration window.
Configuring Primary/Secondary Target Parameters
To configure the iSCSI primary and secondary target parameters:
1. In the QConvergeConsole system tree, select an adapter, and then select
the appropriate port.
2. In the content pane on the right, click Boot Configuration.
3. Click the iSCSI Boot button.