Users Guide

5–Fibre Channel Noninteractive Commands
-qos (Quality of Service [QoS])
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 80 Copyright © 2021 Marvell
To view the current QoS settings of all virtual ports on a physical adapter port,
issue the -qos command as follows:
qaucli -pr fc -qos <hba instance>|<hba wwpn> info --vp all
[--per|--spd]
Where:
To view the current QoS settings of a specific virtual port on a physical adapter
port, issue the -qos command as follows:
qaucli -pr fc -qos <hba instance>|<hba wwpn> info --vp
<vport wwpn> [--per|--spd]
Where:
To change the QoS settings of a specific virtual port, issue the -qos command as
follows:
qaucli -pr fc -qos <hba instance>|<hba wwpn> --vp <vport wwpn>
[<option>]
Where:
<hba instance> = Adapter number (use the -g command to find)
<hba wwpn> = World wide port name of the adapter
all = Reports QoS settings for all virtual ports on the adapter port
--per = Display bandwidth percentage-related QoS settings only
--spd = Display bandwidth speed-related QoS settings only
<hba instance> = Adapter number (use the -g command to find)
<hba wwpn> = World wide port name of the adapter
<vport wwpn> = World wide port name of the virtual port
--per = Display bandwidth percentage-related QoS settings only
--spd = Display bandwidth speed-related QoS settings only
<hba instance> = Adapter number (use the -g command to find)
<hba wwpn> = World wide port name of the adapter
<vport wwpn> = World wide port name of the virtual port
<option> One of the following options:
--pri <priority>
--bwspd <speed> [Gbps|Mbps]
--bwper <percent>
--lock <lock op>
--enable <enable op>