Users Guide

5–Fibre Channel Noninteractive Commands
-fs (Driver Parameters)
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 49 Copyright © 2021 Marvell
-fs (Driver Parameters)
To configure the driver settings, issue the following command:
qaucli -pr fc -fs <hba instance>|<hba wwpn>
(<param name>|<param alias> <param value>)...
Where:
The pairs <param name> <param value> and <param alias> <param
value> can be repeated to set multiple parameters in a single command.
Table 5-4 lists the driver configuration parameter names and aliases.
NOTE
The -fs option is not supported for Linux. The following error appears
when issuing this command on a Linux system:
Feature is unsupported with current driver!
<hba instance> = Adapter instance number of an adapter port (use the -g com-
mand to find)
<hba wwpn> = World wide port name of the adapter
<param name> = Name of the parameters
<param alias> = Alias of the parameters
<param value> = New value of the parameters
Table 5-4. Driver Settings Parameters
Description
Parameter Name
<param name>
Alias
<param
alias>
Value
a
<param
value>
a
0 = Disabled, 1 = Enabled
Persistently bound target(s) only PersistentOnly PO 0, 1
Present persistently bound target(s) plus any new
target(s) with driver default
PersistentPlusNew PN 0, 1
Present targets with driver default
NewOnly
b
b
Driver parameter NewOnly (NO) is supported only with the failover driver.
NO 0, 1
Bind devices by WWPN BindWWPN BW 0, 1
Bind devices by port ID BindPortID BP 0, 1